grain Posted March 20, 2014 Share Posted March 20, 2014 Hi, There doesn't seem to be an option to plot to PDF with layers. (I have gone into the custom properties but there is no option to 'retain layer information'. Thats using PDF to Dwg.pc3 I also have CutePDF Writer that doesnt have the option either. Maybe you have to get Acrobat Pro? Quote Link to comment Share on other sites More sharing options...
steven-g Posted March 20, 2014 Share Posted March 20, 2014 Take a look at publish rather than plot, I can get at that in the publish options. Quote Link to comment Share on other sites More sharing options...
grain Posted March 20, 2014 Author Share Posted March 20, 2014 Hi Steven, I only seem to be able to Publish to the DWF electronic format. Quote Link to comment Share on other sites More sharing options...
steven-g Posted March 20, 2014 Share Posted March 20, 2014 Then it might not be available in 2009 Quote Link to comment Share on other sites More sharing options...
grain Posted March 20, 2014 Author Share Posted March 20, 2014 Thanks anyway. I'll probably look into some more advanced PDF software. Quote Link to comment Share on other sites More sharing options...
lamensterms Posted March 20, 2014 Share Posted March 20, 2014 Hi grain, If you cannot retain layer information while publishing from ACAD 2009 (or earlier)... You could just install DWG TrueView and use that for all your publishing. You should be able to publish to PDF and keep your layers, no worries. Good luck. Quote Link to comment Share on other sites More sharing options...
grain Posted March 20, 2014 Author Share Posted March 20, 2014 Thanks Lamensterms. That works perfectly. Quote Link to comment Share on other sites More sharing options...
lamensterms Posted March 20, 2014 Share Posted March 20, 2014 No problem grain, glad I could help. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.