SRN Posted June 23, 2017 Share Posted June 23, 2017 is there any way to more an item from one layer to another without having to recreate it on the destination layer. This is in Autocad 2015LT Quote Link to comment Share on other sites More sharing options...
steven-g Posted June 23, 2017 Share Posted June 23, 2017 The quickest way is select the item(s), and open the properties palette, and select the new layer from the layer names drop down list (if you have the layer list on the QAT you can do the same there or again with the layer list in the ribbon), or from the command line with the command "change", there's probably a couple more ways as well Quote Link to comment Share on other sites More sharing options...
SRN Posted June 23, 2017 Author Share Posted June 23, 2017 thanks that works Quote Link to comment Share on other sites More sharing options...
Dadgad Posted June 23, 2017 Share Posted June 23, 2017 I would probably do it like steven suggested, it could also be done with the Offset command. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.