PJ01 Posted October 4, 2017 Share Posted October 4, 2017 Hello, as a raw newbie, I have made a 100 x 200mm rectangle on my Model tab, and on the Layout tab, have prepared an A4 sheet, with border and Vport and Title block. However, the drawing does not show up on my Layout Can anyone please advise any steps I may have missed? Quote Link to comment Share on other sites More sharing options...
ReMark Posted October 4, 2017 Share Posted October 4, 2017 Did you activate the layout viewport then do a zoom > all or zoom > extents? Quote Link to comment Share on other sites More sharing options...
Dadgad Posted October 4, 2017 Share Posted October 4, 2017 (edited) Welcome to CADTutor PJ01. Double click into your Viewport, then Zoom Extents. Whoops, ReMark to the rescue. Edited October 5, 2017 by Dadgad Quote Link to comment Share on other sites More sharing options...
PJ01 Posted October 4, 2017 Author Share Posted October 4, 2017 Thank you, this worked perfectly. And the 1:1 print out measured exactly 200 x 100 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.