jkremer1983 Posted November 29, 2017 Share Posted November 29, 2017 I'm a bit new to Inventor and created a basic sheet metal part with flanges and am receiving the error message "Could not split between bend and plate..." Could someone help with this? B0625-44-003.zip Quote Link to comment Share on other sites More sharing options...
ballsdeep89 Posted December 11, 2017 Share Posted December 11, 2017 I haven't downloaded your zip file, though you may consider setting up your sheet metal defaults, and rather than using the bend command, try using the flange command. Quote Link to comment Share on other sites More sharing options...
ajamit007 Posted December 28, 2017 Share Posted December 28, 2017 You've created Sheet Metal Part in 3D Modelling Environment, instead of "Extrude Cut" you should use Cut Across Bend Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.