chrisdarmanin Posted December 6, 2017 Share Posted December 6, 2017 help as this is driving me crazy I export part of a drawing with wblock and set the basepoint such as the lift shaft. then I start a new drawing and insert the exported block as xref. The UCS 0,0 is not as the basepoint as I specified when I exported with wblock. Am I missing something? I need the basepoint to insert at 0,0 Quote Link to comment Share on other sites More sharing options...
CyberAngel Posted December 6, 2017 Share Posted December 6, 2017 Have you checked the INSBASE variable in the destination drawing? Have you opened the WBLOCKed drawing and verified the base point? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.