Zarrah Posted February 22, 2009 Share Posted February 22, 2009 I am pretty much starting off from scratch, everything was such a mess! End result desired: - Metric and Imperial Library? - Layer standards - Plot standards Should I specify lineweights within the blocks? - And then have plot lineweights set-up by object lineweights? The lineweights were previously specified by color, but it doesn't work. (Office wants all electrical to pop-out and all other-architectual-to be the same thin lineweight). Any hints? Tips? Quote Link to comment Share on other sites More sharing options...
tzframpton Posted February 23, 2009 Share Posted February 23, 2009 Well it depends on your plot styles. Are you going to be using CTB or STB Plot Styles? Usually CTB plot styles are used in most plotting environments with AutoCAD. Most people on this forum board uses CTB. Assuming this, its highly recommended to set all entities within blocks to "ByBlock". Of course there will be acceptions to that rule, if you need certain things within the block to plot thinner or thicker then you would assign a color to it that will not change. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.