PeteUK Posted March 12, 2009 Share Posted March 12, 2009 Hey Does anyone know of a BS standard line type for showing internal hot and cold water feeds? Also internal foul waste pipes? Looking to find out whether they are dashed / dashdot, dash-double dot etc etc. Quote Link to comment Share on other sites More sharing options...
A1DWG Posted March 12, 2009 Share Posted March 12, 2009 Hi, I think they are not covered by BS anymore, since BS1192 was rewritten, I have seen the "standard" linetypes with "HW" and "CW", and CH flow CH return, sprinkler, etc. Foul water can either be shown as a dashed / hidden as it is beneath the floor, or more correctly as a dash dot or dash double dot, Surface shown as dashed. Quote Link to comment Share on other sites More sharing options...
PeteUK Posted March 13, 2009 Author Share Posted March 13, 2009 Thanks - I have the 'HW' linetype in AutoCAD 2008 but no CW, can you tell me where I can get this? Quote Link to comment Share on other sites More sharing options...
JONTHEPOPE Posted March 13, 2009 Share Posted March 13, 2009 you could try to change line just do this search for ***.lin file save as new.lin than chage needed code see below *Cold_WATER_SUPPLY, water supply ---- cw ---- cw ---- cw ----A,.5,-.2,["cw",STANDARD,S=.1,R=0.0,X=-0.1,Y=-.05],-.2 *other_WATER_SUPPLY,Hot water supply ---- ot ---- ot ---- ot --A,.5,-.2,["ot",STANDARD,S=.1,R=0.0,X=-0.1,Y=-.05],-.2 now load line by chosing other and find where you saved file pick line change must be second line after ["**" etc Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.