atsay714 Posted April 11, 2009 Share Posted April 11, 2009 This is a 3d isometric drawing, and I'm extruding the circles along the X axis, but I can't figure out how to draw that one line. Anyone have any ideas? Quote Link to comment Share on other sites More sharing options...
JD Mather Posted April 12, 2009 Share Posted April 12, 2009 Model like you would machine the actual part - drill the holes last. Extrude the Ø2.250 circle to 1.594 - the center of the part. Then Union. After you have the entire solid then drill (presspull) the holes. Quote Link to comment Share on other sites More sharing options...
totzky Posted April 12, 2009 Share Posted April 12, 2009 Model like you would machine the actual part - drill the holes last.Extrude the Ø2.250 circle to 1.594 - the center of the part. Then Union. After you have the entire solid then drill (presspull) the holes. Since you have already extruded the circle by a certain height, try offset face (solidedit). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.