JerryG Posted June 19, 2009 Share Posted June 19, 2009 I have built a corridor surface by creating an alignment from an existing corridor then targeting to another alignment/profile. This all worked great but I cannot get the contours to show up for the new corridor surface. I have created boundary's through the corridor properties, but when I try and add a boundary from the surface definition I get an error message. Any thoughts? I'm running 2010 Thank you! Quote Link to comment Share on other sites More sharing options...
JerryG Posted June 19, 2009 Author Share Posted June 19, 2009 I also found that when I go into the surface properties and Display everythin it changes the orginal corridor that I created the Alignment from rather than the new corridor/surface. I'm sure this is the problem but I'm not sure how to fix it? Quote Link to comment Share on other sites More sharing options...
JerryG Posted June 23, 2009 Author Share Posted June 23, 2009 Turns out I simply had to click the Plus Icon in corridor properties under surface (once a surface was created) and woala - contours show up. This is because you have to specify that the surface you want the contours to show up on is the TOP surface and not the Datum, Median, etc. surface (if you have those for volume calcs) Hope that helps Quote Link to comment Share on other sites More sharing options...
PEGAdevelopment Posted July 18, 2013 Share Posted July 18, 2013 Thanks JerryG, this helped me alot! I now have contours on my corridor woohoo! Quote Link to comment Share on other sites More sharing options...
JerryG Posted September 26, 2013 Author Share Posted September 26, 2013 Sure - Glad an Old post helped you out! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.