CadDan Posted July 26, 2009 Share Posted July 26, 2009 I'm trying to do a floor plan. When I go to polylines and put two together and do their width, it comes up with them touching but leaving a little space between two of the corners (circled in red). I simply can't make it look like one polyline. Quote Link to comment Share on other sites More sharing options...
CadDan Posted July 26, 2009 Author Share Posted July 26, 2009 Well that was an easy fix. The answer was right in front of me the whole time. All I had to do was fillet them and put radius to 0. Quote Link to comment Share on other sites More sharing options...
eldon Posted July 27, 2009 Share Posted July 27, 2009 If you had used PEDIT to join the two polylines, you would not have had the problem. In fact, by using Fillet, you have actually joined the two polylines. Quote Link to comment Share on other sites More sharing options...
CadDan Posted July 27, 2009 Author Share Posted July 27, 2009 I realized that as I went to the fourth corner (just trying it out). Thanks for that PEDIT command tip. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.