stevsmith Posted August 17, 2009 Share Posted August 17, 2009 I do all the company drawings on the 2010 system in my office. When I set the ltscale to say 10 and save and plot, I have no problems. If I go into the workshop which uses 2007 and open the same drawing i have just complete, the ltscale is set at 10 (as you would expect it to be) BUT!! the image on the screen shows the dashed line x10 smaller as if the ltscale was set at 1. (hope i'm not losing you here) Now. When I print form the workshop computer, (this is the same drawing) the dashed lines appear smaller than the drawing printed from my computer. To make matters worse. I have 2010 at home. and with the same templates from my office computer, It does the same as the workshop computer. Ive tried psltscale and celtscale, but nothing seems to rectify the problem. Any ideas??????????? PLEASE:cry: Quote Link to comment Share on other sites More sharing options...
stevsmith Posted August 19, 2009 Author Share Posted August 19, 2009 Anybody??? Quote Link to comment Share on other sites More sharing options...
stevsmith Posted August 19, 2009 Author Share Posted August 19, 2009 57 views and not 1 piece of help Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.