clionutta Posted August 26, 2009 Share Posted August 26, 2009 Hello all, my Autocad 2009 keeps on mucking up my cicles and arcs every so often, and i dont know how to stop it. When i draw them, they tend to be fine, and smooth, but sometimes when i reopen a drawing the arcs and circles are all pointed, and the drawing looks naff. Is there any way to fix this? Kind regards David Quote Link to comment Share on other sites More sharing options...
chulse Posted August 26, 2009 Share Posted August 26, 2009 Does regen clean it up? Increase your VIEWRES value... Quote Link to comment Share on other sites More sharing options...
ReMark Posted August 26, 2009 Share Posted August 26, 2009 What is Viewres set to? Quote Link to comment Share on other sites More sharing options...
clionutta Posted August 26, 2009 Author Share Posted August 26, 2009 how do i check my viewres? Quote Link to comment Share on other sites More sharing options...
clionutta Posted August 26, 2009 Author Share Posted August 26, 2009 regen cleaned it up. Thanks Quote Link to comment Share on other sites More sharing options...
chulse Posted August 26, 2009 Share Posted August 26, 2009 Type VIEWRES on the command line and see what it says... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.