Primal Scientist Posted November 12, 2009 Share Posted November 12, 2009 Hi All, Is there a quick way I can find out a center line of a road that has been drawn. What I have basically, is a poly line that goes round the edge of a road. It is a little complex, but I need to draw a new poly line down the center. Please help!! Thanks Darren. Quote Link to comment Share on other sites More sharing options...
Jay Dee Posted November 12, 2009 Share Posted November 12, 2009 Is the width of the road uniform?? Quote Link to comment Share on other sites More sharing options...
Primal Scientist Posted November 12, 2009 Author Share Posted November 12, 2009 Unfortunately no. Quote Link to comment Share on other sites More sharing options...
Jay Dee Posted November 12, 2009 Share Posted November 12, 2009 didnt think so........ dont think there is a quick way around this. Im very interested to see if there is though as iv had the same task before. I ended up having to mark chainage points on each side of road, drawing a line from each respective point then drawing a line from centre point to centre point. Not ideal I know but thakfully it looked the part and centreline was for indicative purposed only so it got the job done. Good luck! Quote Link to comment Share on other sites More sharing options...
Primal Scientist Posted November 12, 2009 Author Share Posted November 12, 2009 Many thanks anyway. Darren. Quote Link to comment Share on other sites More sharing options...
rkent Posted November 12, 2009 Share Posted November 12, 2009 Try this lisp out, not mine. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.