tapkawiman Posted January 19, 2010 Share Posted January 19, 2010 I have not used this in some 10 years and have problems remember how to set my limits. I am trying to draw a bathroom roughly 12'x25' when I use the setup wizard I set my limits larger than my drawing. Then when I go to my drawing it wont let me draw anything much over 5' wide. Not quite sure what I am doing wrong but any help would be greatly appreciated. Quote Link to comment Share on other sites More sharing options...
ScribbleJ Posted January 19, 2010 Share Posted January 19, 2010 Don't worry about setting up limits. To draw a rectangle type in rec (or spell it out completely) then choose the D option and give it the length and width of 12 and 25 respectively. Use zoom extents command. Quote Link to comment Share on other sites More sharing options...
New2CADmike Posted January 20, 2010 Share Posted January 20, 2010 If you go to View-Regen..then it will allow you to pan over to a larger area..but the larger area will have its limits..just regen again if it isn't big enough again Quote Link to comment Share on other sites More sharing options...
tapkawiman Posted January 20, 2010 Author Share Posted January 20, 2010 Thank You For The Help!!!!!!!!!!! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.