humaironline Posted February 4, 2010 Share Posted February 4, 2010 Kindly help me to draw a 3d helmet in cad 2010. humair Quote Link to comment Share on other sites More sharing options...
Tiger Posted February 4, 2010 Share Posted February 4, 2010 I think a REVOLVE should do most of it. Then a SWEEP for the brim. Quote Link to comment Share on other sites More sharing options...
ReMark Posted February 4, 2010 Share Posted February 4, 2010 If the helmet is wider, front to back, than it is side to side I'm not sure that a simple Revolve would achieve the correct profile. As for the brim would Rulesurf be a good option using a portion of the front of the helmet curve and the edge of the brim as the two lines that could define the mesh? Just thinking out loud here. There are probably two or three other ways to achieve the same goal I haven't even considered (lack of coffee...must have coffee...now). The task is brimming with possibilities! My mind perks with ideas! Quote Link to comment Share on other sites More sharing options...
JD Mather Posted February 4, 2010 Share Posted February 4, 2010 Find the Mesh on-line classes here http://au.autodesk.com Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.