RUSSOMSTUDIO Posted June 10, 2010 Share Posted June 10, 2010 I'm trying to move objects in order to line them up on a common centerline. But each time I move an object from the m command: the object moves on two planes. one lining up on my center and the other changing elevation for example. I dont want it to change in elevation. any suggestions? Quote Link to comment Share on other sites More sharing options...
ReMark Posted June 10, 2010 Share Posted June 10, 2010 You're working in 3D? Quote Link to comment Share on other sites More sharing options...
RUSSOMSTUDIO Posted June 10, 2010 Author Share Posted June 10, 2010 Yes, Or A Glorified Iso. Its A Employer Modified Workspace Quote Link to comment Share on other sites More sharing options...
bjschw Posted June 10, 2010 Share Posted June 10, 2010 Use point filters to move the object only on the plane you want to. Quote Link to comment Share on other sites More sharing options...
einstainas Posted June 10, 2010 Share Posted June 10, 2010 can you post image. cause its hard to understand that you want to do ... Quote Link to comment Share on other sites More sharing options...
ReMark Posted June 10, 2010 Share Posted June 10, 2010 Not sure I understand the "glorified ISO" comment. Are you working in 3D using one of the four predefined isometric views (SE, NE, SW or NW)? Quote Link to comment Share on other sites More sharing options...
RUSSOMSTUDIO Posted June 10, 2010 Author Share Posted June 10, 2010 Yes With The Ability To 3d Orbit Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.