camillo villafranca Posted June 25, 2010 Share Posted June 25, 2010 In A2009, although I set up the parameters in "Units" to be 360 degrees, the whole circle bearing is "split" in 2 quadrant i.e. 0-180 therefore your 235d35'50" does not draw at the wanted bearing but it depends from where your mouse is pointing in which quadrant. Why? Is there a parameter I must update? Ta Quote Link to comment Share on other sites More sharing options...
eldon Posted June 25, 2010 Share Posted June 25, 2010 Although one must guess at what you are doing, I think that you want to dimension a line bearing by using the Angular Dimension. The Angular dimension only goes up to 180°. That is how it was designed. But you can dimension an angle Vertex and get an angle greater than 180° Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.