CAD911 Posted July 1, 2010 Share Posted July 1, 2010 I’m new to inventor and am trying to figure out how to toggle through selections with a key board shortcut. I find it slow using the arrows and selecting the green dot. It's a lot easier to do using AutoCAD. Thanks CAD911 Quote Link to comment Share on other sites More sharing options...
MarkFlayler Posted July 1, 2010 Share Posted July 1, 2010 You can scroll your mouse wheel too. Quote Link to comment Share on other sites More sharing options...
Lazer Posted July 2, 2010 Share Posted July 2, 2010 In the Application Options under the General tab and look at the bottom right under selection, you can change the delay time and speed it up as it scrolls through the selection. Quote Link to comment Share on other sites More sharing options...
CAD911 Posted July 4, 2010 Author Share Posted July 4, 2010 Thank You So I guess there are no keyboard short cuts for this. Quote Link to comment Share on other sites More sharing options...
JD Mather Posted July 4, 2010 Share Posted July 4, 2010 Select other is automatic - no keyboard shortcut needed. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.