Andecal23 Posted September 14, 2010 Share Posted September 14, 2010 I have a question about data extraction in AutoCAD Architectural 2009. I have an original drawing of a floorplan of a building. On this drawing I draw polylines with hatches above the original drawing to calculate areas and lengths of the walls. With data extraction (table) I can get all the values of the polylines and hatches (Length and Area) but is there a possibility to give each line of the table automatically a seperate number and put these numbers also at the polyline or in the hatch so I can see where which value is located when I plot these drawings. Quote Link to comment Share on other sites More sharing options...
bass_mark00 Posted September 15, 2010 Share Posted September 15, 2010 You may want to investigate using FIELDS. The label on your drawing could then be linked to a cell on your table. Change the label and the linked cell would update. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.