numberOCD Posted September 21, 2010 Share Posted September 21, 2010 (edited) Hey AutoCADians, I'm working on a projection of (4) sets of (4)L4x4x3/8 to show the offset from the expected location. The offset is down to as small as 0.0045'. When I show a close up perspective view of the end of the L-Brackets, my first (3) sets come out good and close in a 3.45"x3.71" viewport; but the forth keeps cutting into the L-Brackets. Anyone have any tips to set the boundaries of that perspective view cutoff or anything about possible technique?? Edited September 21, 2010 by numberOCD Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.