RKINGFP Posted November 5, 2010 Share Posted November 5, 2010 A common need for me is to tie two horizontal pipes together with a vertical pipe. The horizontal pipes are at different elevations, directions and sometimes sloping. Have just starting with MEP and figure there must be an easy way to do this. Quote Link to comment Share on other sites More sharing options...
frankcad Posted November 17, 2010 Share Posted November 17, 2010 set up your routing preferences. make a new one or modify one to your needs. you should be able to click the end of one of the horizontal pipes, click the + sign and then click the vertical pipe, it should auto route throwing in w,e, fitting you have set for a tee (san tee, LTTY) hope that helps... routing preference only goes so far, really weird combos you will need to manually place fittings, usually rolling fittings and stuff like that Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.