skenderbender17 Posted March 22, 2011 Share Posted March 22, 2011 Hello! I'm having an issue with my poly lines. they aren't filling in. And its only in one drawings. Even if I do a solid it comes in not tilled in. I tried doing the fillmode but that didnt work. I tried the shademode but that didnt work either. I'm not sure what else to try. Any ideas? Thankk youu,! Quote Link to comment Share on other sites More sharing options...
Grant Posted March 22, 2011 Share Posted March 22, 2011 Is your polyline 'closed' type list and if it says open then it is not a closed polyline. See if you can region the polyline If the polyline is not 'closed' Try Pedit and go E for edit vertices where the 'X' is is where the fault should be Quote Link to comment Share on other sites More sharing options...
skenderbender17 Posted March 22, 2011 Author Share Posted March 22, 2011 I just tried what you suggested and it didnt work either! I'm not exactly sure what to do for this... Quote Link to comment Share on other sites More sharing options...
rkent Posted March 23, 2011 Share Posted March 23, 2011 UCS, World then Plan, World Quote Link to comment Share on other sites More sharing options...
skenderbender17 Posted March 23, 2011 Author Share Posted March 23, 2011 ahhh thanks so much! that worked! Quote Link to comment Share on other sites More sharing options...
Bill_601 Posted October 11, 2012 Share Posted October 11, 2012 That worked for me, too. But I'd like to understand what was happening. What was the hollowness of the lines telling me and what did the UCS and Plan commands do? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.