woodman78 Posted April 5, 2011 Share Posted April 5, 2011 Hi, I am new to Civil 3d. I am trying out a few of our schemes in Civil to see how they run. I have created a surface, an alignment and a profile view. I have then created my profile but when I finished I expected the proopsed levels to change to reflect my profile rather than still reading as existing levels. I created an assembly and then created the corridor but I am not getting any cut and fill shown on the alignment. I 'm sure I left out something very simple so I would be grateful if someone could point it out. Thanks. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.