Gmalone12 Posted April 13, 2011 Share Posted April 13, 2011 When two flow lines cross eachother they make a break automatically, but it is so small you can't see it unless I zoom way in. How do you change this? THanks in advance. Quote Link to comment Share on other sites More sharing options...
irwin5338 Posted January 27, 2012 Share Posted January 27, 2012 I am not sure if you found a solution to this problem, but here it is. Go to the project manager and right click, then select properties. This will take you to project setup. On the left pane, Expand the P&ID DWG settings, then select line settings. On the top of the right pane, you should see a value for gap/loop width. Adjust this to whatever suits your needs. Hope I was able to help. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.