Browny_76 Posted August 2, 2011 Share Posted August 2, 2011 I was wondering if there was a way to break dimension extension lines around other dimension lines?? Similar to the picture below. Quote Link to comment Share on other sites More sharing options...
MSasu Posted August 2, 2011 Share Posted August 2, 2011 Can you clarify please which CAD is your question referring? It is posted in SolidWorks section and you profile states AutoCAD. Thank you. Regards, Mircea Quote Link to comment Share on other sites More sharing options...
Browny_76 Posted August 2, 2011 Author Share Posted August 2, 2011 Sorry about that. My question refers to SolidWorks. I predominately use AutoCad, but i have recently started using Solidworks Quote Link to comment Share on other sites More sharing options...
Pablo Ferral Posted August 2, 2011 Share Posted August 2, 2011 AutoCAD = 'DIMBREAK' command. Quote Link to comment Share on other sites More sharing options...
Browny_76 Posted August 3, 2011 Author Share Posted August 3, 2011 Thanks for the reply, but my question refers to if this is possible in SolidWorks?? Quote Link to comment Share on other sites More sharing options...
shift1313 Posted August 4, 2011 Share Posted August 4, 2011 when the dimension property tab is open there are 3 sections that you can tab to. Value, Leaders, Other. On the Leader section there is a box that says Break Lines. If you check that box you can do this. Hopefully this picture explains that a little better Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.