monk Posted August 18, 2011 Share Posted August 18, 2011 Hello. I have this lisp which I can't remember where I got it from and take no responsibility for the creation. But you can only draw two lengths with a bend. I would love it if you could draw continuously or at least quite a few more points. Is this possible? This is a perfect spiral duct drawing lisp because it adds both centre and small ends! duct.lsp Quote Link to comment Share on other sites More sharing options...
nachia Posted June 27, 2015 Share Posted June 27, 2015 how dose working ? Quote Link to comment Share on other sites More sharing options...
vlados Posted June 27, 2015 Share Posted June 27, 2015 I do not remember the author ... pipes+elbows.LSP Quote Link to comment Share on other sites More sharing options...
ashfaq431 Posted September 29, 2016 Share Posted September 29, 2016 check the lisp below. it will help you for pipes+elbows lisp Quote Link to comment Share on other sites More sharing options...
Ronso Posted September 30, 2016 Share Posted September 30, 2016 See http://www.cadtutor.net/forum/showthread.php?10882-Need-better-multiline&p=670389#post670389 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.