Sparky Posted September 16, 2011 Share Posted September 16, 2011 Good Afternoon, In our office cutlines are made up of polylines. When I use this in an annotative drawing I cannot get the polyline to change with the scale factor. Is there a way to make the polyline annotative? Does this make sense? Thanks! Quote Link to comment Share on other sites More sharing options...
rkent Posted September 16, 2011 Share Posted September 16, 2011 Are you talking about linetypes not adjusting, or width of pline, length of pline, or..? Quote Link to comment Share on other sites More sharing options...
Sparky Posted September 16, 2011 Author Share Posted September 16, 2011 I have attached a drawings showing a cutline for a steel beam. When I change the annotation scale the size of the cutline does not change. Thanks cutline.dwg Quote Link to comment Share on other sites More sharing options...
rkent Posted September 16, 2011 Share Posted September 16, 2011 Oh, that would have to be a block, ordinary objects are not annotative. Quote Link to comment Share on other sites More sharing options...
Sparky Posted September 16, 2011 Author Share Posted September 16, 2011 That's what I was afraid of, Thanks! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.