Sparky Posted September 19, 2011 Share Posted September 19, 2011 Morning, I have a steel angle block cut in section with the ANSI 32 hatch pattern with a hatch scale of 2, the hatch is annotated. The block was created at 1:1. When I insert the block into my section (Anno scale @ 3/4" =1'-0") The hatch pattern is way out of scale unless I change the annotation scale of the section to 1:1, then the hatch pattern for the block I created looks correct. I tried using the "Annotativedwg" command but I do not need the oblect lines of the block to be annotative so this did not work. Suggestions? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.