taiwanchu Posted January 5, 2012 Share Posted January 5, 2012 Anyone have the issue with clicking on the new layer button in the layer manager and it brings up the dialogue box for starting a new drawing with a template? Running ACADLT2010. Quote Link to comment Share on other sites More sharing options...
ReMark Posted January 5, 2012 Share Posted January 5, 2012 Is this a new install of 2010? Quote Link to comment Share on other sites More sharing options...
taiwanchu Posted January 5, 2012 Author Share Posted January 5, 2012 I have had this installed for quite some time. It just started happening a few days ago. Quote Link to comment Share on other sites More sharing options...
ReMark Posted January 5, 2012 Share Posted January 5, 2012 Have you been doing any customization? Have you tried the REPAIR option? Quote Link to comment Share on other sites More sharing options...
taiwanchu Posted January 5, 2012 Author Share Posted January 5, 2012 No to both. You will have to tell me about the REPAIR option. Not sure LT has this as it is an unknown command when typed in. Quote Link to comment Share on other sites More sharing options...
ReMark Posted January 5, 2012 Share Posted January 5, 2012 It is not an AutoCAD command. The REPAIR option is found in Windows > Add/Remove Programs under AutoCAD LT. It will attempt to repair a faulty installation. First though, did you try shutting your system down completely then rebooting? I'm referring to a "cold" boot not a "warm" boot. Quote Link to comment Share on other sites More sharing options...
taiwanchu Posted January 5, 2012 Author Share Posted January 5, 2012 Have done the other things. Will try the Repair. Quote Link to comment Share on other sites More sharing options...
ReMark Posted January 5, 2012 Share Posted January 5, 2012 Have you downloaded and installed all service packs for 2010 LT? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.