bigern87 Posted June 28, 2012 Share Posted June 28, 2012 I am trying to combine the layers on a warehouse map into one layer. Is there an easy way to do this? Right now the layers are setup based on the types of architecture and my ultimate goal is to make layers based on the departments that work in each section. Quote Link to comment Share on other sites More sharing options...
BlackBox Posted June 28, 2012 Share Posted June 28, 2012 Welcome to CADTutor! Consider the LAYMRG Command. Quote Link to comment Share on other sites More sharing options...
Dadgad Posted June 29, 2012 Share Posted June 29, 2012 +1 Absolutely the way to go. Quote Link to comment Share on other sites More sharing options...
bigern87 Posted July 2, 2012 Author Share Posted July 2, 2012 I get the error message "Cannot merge current layer" for a few of the layers that I am trying to merge into this. In the properties I don't see anything different with the objects; also in the layer properties I don't see anything different compared to the other layers. The file size seems to be a bit too large (16mb) otherwise I would attach it here. Quote Link to comment Share on other sites More sharing options...
rkent Posted July 2, 2012 Share Posted July 2, 2012 Grab all the objects, pick a layer, done. If you have 100 layers and 20 go on one layer, and 20 on another, etc, then freeze them all, thaw the 20 you need, then see above. Quote Link to comment Share on other sites More sharing options...
Doove Posted July 11, 2012 Share Posted July 11, 2012 Layer Translator will do it too. (LAYTRANS) Quote Link to comment Share on other sites More sharing options...
RobDraw Posted July 11, 2012 Share Posted July 11, 2012 I get the error message "Cannot merge current layer" for a few of the layers that I am trying to merge into this. In the properties I don't see anything different with the objects; also in the layer properties I don't see anything different compared to the other layers. The file size seems to be a bit too large (16mb) otherwise I would attach it here. Change your current layer to one that is not involved in the merging. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.