Jump to content

3D the block from design center using autocad 2012

rhyneheart_28

By rhyneheart_28
in AutoCAD 3D Modelling & Rendering

 Share

Recommended Posts

ReMark Grand Master

ReMark

Posted
Posted

You would have to first explode it. To give it height you could use the PressPull command. There will be other work involved but that's a start.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...