Markthe Shark Posted November 8, 2013 Share Posted November 8, 2013 Hi all, I have drawn up a moment and deflection line for a beam and it seems that the titles in the table are German?? I cannot seem to find the settings where I can change this. I have done this many times before and never had this problem... Can anyone help? Quote Link to comment Share on other sites More sharing options...
MSasu Posted November 8, 2013 Share Posted November 8, 2013 What tool did you used to draw that? Is about an AutoLISP tool (since the thread is in development section)? If yes, are you allowed/able to post it for someone to check it for you? Quote Link to comment Share on other sites More sharing options...
Markthe Shark Posted November 8, 2013 Author Share Posted November 8, 2013 thanks Mircea, I'm not sure what you mean. I used the "Deflection Line" tool under the Content tab in AutoCAD mechanical 2012. I am trying to post the file Quote Link to comment Share on other sites More sharing options...
MSasu Posted November 8, 2013 Share Posted November 8, 2013 You stated AutoCAD Vanilla under your profile; there is no such tool in that, so there my questions. Now it seems that is included in Mechanical pack; this information will allow someone with knowledge in this vertical product to give you an answer. My also help to ask a Moderator to fix the location of your thread. Quote Link to comment Share on other sites More sharing options...
SLW210 Posted November 8, 2013 Share Posted November 8, 2013 Thread has been moved to AutoCAD Vertical Products Mechanical Forum. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.