Jump to content

Autocad Mechanical 2009 - Bolt pattern dimensions.

Smackre

By Smackre
in AutoCAD Drawing Management & Output

 Share

Recommended Posts

Smackre Newbie

Smackre

Posted
Posted

Hello,

 

Trying to do some bolt pattern center lines. Been doing them for years and can do them old school way. But was wondering if there is a better ways. If you put a circle from the center of the bolt circle to the center of the bolts and change it to center the hashes never line up. So I always do small center line sections on each bolt hole. Then array it around to cover the entire bolt circle. But that gets time consuming. I am now doing a lot of projects with bolt circles and wondered if there was a better method.

 

Eric,

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...