BKETC30 Posted November 19, 2014 Share Posted November 19, 2014 I need to correct a group of points collected from bad coordinates on a control point to the corrected coordinates of the same control point. Is there a way to shift the whole set?Any ideas? Quote Link to comment Share on other sites More sharing options...
rkmcswain Posted November 19, 2014 Share Posted November 19, 2014 Using Civil 3D 2014 as your profile says? Is this is more than a simple move? Maybe a move, scale, and rotate? Quote Link to comment Share on other sites More sharing options...
BKETC30 Posted November 19, 2014 Author Share Posted November 19, 2014 Thanks. That was easy enough. I'm new to this and its hard to get a straight answer sometimes even the simple ones. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.