myrelyre Posted March 2, 2015 Share Posted March 2, 2015 Hey Guys, I'm needing to model a stair stringer in 3d that sweeps in all 3 directions. See attached jpeg for what i've done so far. I'm trying to create fabrication drawings from it and can't figure out how to add detail of all the pieces that will create the stringer. Quote Link to comment Share on other sites More sharing options...
Dadgad Posted March 3, 2015 Share Posted March 3, 2015 Welcome to CADTutor. You might find the following link helpful http://www.cadtutor.net/forum/showthread.php?87802-Relatively-Painless-3D-Modeling-of-A-Potentially-Troublesome-Unistringer it describes the steps I went through on a somewhat similar project. Not exactly, as mine had a Unistringer, but it may help shed some light, I hope so. It looks like you are doing pretty well so far! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.