How to check the origin location of an existing hatch?

How to check the origin location of an existing hatch so that i can align the new hatch patten to?

Thanks

Here is the answer to your question just have a look at the properties available. Use VLA-GET-ORIGIN, so much is simply available and much easier than using dxf codes.

;;;===================================================================; 
;;; DumpIt                                                            ; 
;;;-------------------------------------------------------------------; 
;;; Dump all methods and properties for selected objects              ; 
;;;===================================================================; 
(defun C:DumpIt ( / ent) 
 (while (setq ent (entsel)) 
   (vlax-Dump-Object 
     (vlax-Ename->Vla-Object (car ent)) 
   ) 
 ) 
 (princ) 
)

Thanks BIGAL

It listed the hatch

Origin = (0.0 0.0)

are there coordinates?

I click hatch origin as 0,0 but patten still do not match.

Any advise?