eribiste Posted July 9, 2015 Share Posted July 9, 2015 Hello Folks, I think I'm having an attack of the dumbs again. I'm trying to annotate an Inventor 2D drawing of an elliptical component with centerlines, and I can't persuade any of the centreline tools to do this. Any suggestions please? Quote Link to comment Share on other sites More sharing options...
ecshclark Posted July 13, 2015 Share Posted July 13, 2015 Make sure the geometry was sketched using an ellipse, maybe a spline was used? Under the Annotate Tab > Symbols > Centermark and Centerline will both find the center of an ellipse. If a spline was used, there will be no center for Centermark or Centerline to find. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.