perigalacticon Posted April 8, 2016 Share Posted April 8, 2016 Hello, I've been searching the web for Fusion 360 support forums and I have only found the official one, there is no Stack Exchange either. I'm not getting good support at the official one, do you know of sites where I can get help? Thanks Quote Link to comment Share on other sites More sharing options...
SLW210 Posted April 8, 2016 Share Posted April 8, 2016 I'm sure there are a few around here that may use it. Ask your question and give it a try. Quote Link to comment Share on other sites More sharing options...
JD Mather Posted April 13, 2016 Share Posted April 13, 2016 What username are you posting under on the company site? I thought I might take a shot at some of your questions. Quote Link to comment Share on other sites More sharing options...
SLW210 Posted April 14, 2016 Share Posted April 14, 2016 You might check this out http://www.cadtutor.net/forum/showthread.php?96473-Great-Fusion-360-Article-amp-Training-Resources Quote Link to comment Share on other sites More sharing options...
JD Mather Posted April 14, 2016 Share Posted April 14, 2016 Hello, ... I'm not getting good support at the official one, do you know of sites where I can get help? Thanks Do you answer requests for additional information to clarify your questions on the company site? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.