plecs Posted January 14, 2017 Share Posted January 14, 2017 Hello, I need help and do not know how I can make autodimension BOX on the x axis and z axis Thank you in advance for your help if anyone can. I attached a png to see if you can not help http://mariussilviu80.blogspot.ro/ Quote Link to comment Share on other sites More sharing options...
BIGAL Posted January 14, 2017 Share Posted January 14, 2017 You need to use UCS and set the plane for each dimension. You can work out 3pts that represent the block faces and use the UCS 3 option or X & Z rotating 90 degrees. Look at image and you can see the ucsicon is twisted so to enable the vertical dim to be in the plane. Quote Link to comment Share on other sites More sharing options...
plecs Posted January 17, 2017 Author Share Posted January 17, 2017 ok I understand the idea, but I insert blocks in top plan with XYZ, but how do you save that change UCS UCS top XYZ coordinates change. then you have to instead make the front and dimension. But there is another aspect when the exchange UCS what about the origin. when you insert top insert block the origin of UCS exchange board in front origin if such do with it because you have to bring dimension where the block is not anywhere I do not know how to do that Quote Link to comment Share on other sites More sharing options...
plecs Posted January 17, 2017 Author Share Posted January 17, 2017 I tried to change the UCS but I do not know how to change the origin dimension that I put your picture Quote Link to comment Share on other sites More sharing options...
BIGAL Posted January 18, 2017 Share Posted January 18, 2017 UCS 3 the 1st thing asked is origin point. Your blog spot uses the front plane of the box for its dims. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.