Replicate this dynamic block...

Can you replicate this block?

If so, how'd you do it?

Door.dwg

Lt Dan, the area where you posted this thread is for forum competitions, not questions.

I have moved this thread to a more suitable location.

I created this block as a challenge for others.

The Competition section is for forum challenges. These competitions follow specific guidelines, they are set up with rules, there is a time limit, etc. They are typically organized or overseen by a moderator, and when the competition is over, the entries are voted on to decide a winner. Also, the competitions are usually organized beforehand in order to see if there is even any interest in the challenge. Your post didn't give any information regarding the challenge and it reads more like a question of "How do you make something like this" than "Try your hand at making something like this".

If you want to make this an official challenge, create a poll in this thread and see if you get any votes. If you get enough responses, you can create a thread in the Competitions forum similar to this one: http://www.cadtutor.net/forum/showthread.php?25682-Competition-No.-7

But if you just want to see if others can duplicate the block you made, there's really no need to start a competition for that.

That block would be easy to re-create. I've got one that will blow your mind.