Points in Land Desk

When I try to use points to draw a line or define a parcel in Land Desk it does not work.

If I say Pt 1 to Pt 2 and do that twice it will draw two different lines neither for 1 to 2.

The radial stake out works, the points are in the correct location, the drawing file points and project points are the same.

This is land desk 2004, it used to work.

Thanks,

Joe M.

Its been a while since I used LDT but for the USA version your UNITS had to be Length Decimal and Angle Decimal Degrees.

Will try that, but am suspicious, as I just started it is something else.

Thanks Again

Also make sure your UCS is set to World.

Not it, it as though the Line Command and Parcel Command do not see the points.