Tridraft Posted June 12, 2012 Posted June 12, 2012 Working on a 'bumper' and need some turn signals. To turn the bumper at the 6.0" mark toward the same direction as the existing radius using a 20.00" radius for the curvature of the bend, what is the best way to go about this? Is there a secondary bend option that will not contort my original 1.625" radius. Should I loft this instead? Sheetmetal? Thanks. Bumper01.ipt Quote
JD Mather Posted June 12, 2012 Posted June 12, 2012 Rather than Bend Part I think I would simply Sweep the profile. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.