EvanZabadah Posted September 17, 2012 Posted September 17, 2012 What is the best way to roll sheetmetal Quote
JD Mather Posted September 17, 2012 Posted September 17, 2012 The best way - is not to roll sheetmetal. Model it in finished form and have Inventor calculate the flat pattern. Quote
stevsmith Posted September 17, 2012 Posted September 17, 2012 What is the best way to roll sheetmetal ????????????????????????????????????????????????????????????????????????????? Stick it in a set of rollers and press go. Quote
EvanZabadah Posted September 17, 2012 Author Posted September 17, 2012 I thought I was on an Inventor forum not a machine shop forum:) Quote
stevsmith Posted September 17, 2012 Posted September 17, 2012 Touche! Maybe a more descriptive question would deserve a more befitting answer. What are you looking to achieve, a cylinder perhaps? Rolled profile with flanges? Do you have any images you could upload? Quote
JD Mather Posted September 17, 2012 Posted September 17, 2012 Maybe a more descriptive question would deserve a more befitting answer. I gave the OP the best answer there is. Now it is up to the OP to model the part or attach a sketch here so that someone can demonstrate how to use Inventor sheet metal functionality. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.