Jump to content

editing sections

dirtlegg

By dirtlegg
in Civil 3D & LDD

 Share

Recommended Posts

dirtlegg Enthusiast

dirtlegg

Posted
Posted

I have created some section views from sample lines and have great results...however, the elevation range for the surfaces in these sections is about 25 feet but my sections are showing elevation range of about 70 feet. The upper 20 and lower 20 feet is not needed to be shown. How can I get rid of this extra height???

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...