qball Posted April 11, 2013 Posted April 11, 2013 I have this simple dynamic block that is to change from 4" to 6" to 8" square. I have a linear parameter, 0 grips, and a Lookup function for 4, 6 or 8. It is supposed to scale about the midpoint (insertion point). I have tried both the Midpoint and Startpoint settings for Base Location but it always seems to scale from the far left of the Linear Parameter. using 2012 LT WOOD-Column.dwg Quote
Mike_Taylor Posted April 11, 2013 Posted April 11, 2013 Click on your SCALE actions (the small symol), go to properties, under Overrides set the base type to Independent. A grip will appear, simply move it to your desired scaling basepoint. Quote
qball Posted April 11, 2013 Author Posted April 11, 2013 Awesome! Thanks. Is that new? I feel like I used to have no problem with this Action. That the Midpoint Baseline was the setting. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.