Block Problem

Existing Fire Alarm Symbols_.dwg

Can anyone tell me what is wrong with my block.

If you open the block and change between the various different options in the dropdown menu. They all have the same basepoint as I require.

However if you click the last block on the dropdown which is called smoke detector void. The basepoint is different.You can tell it moves to a new point than all the others.

This is causing problems when I insert it into a drawing and switch between the blocks.

I have opened the block up and they are all aligned on top of each other so I can't work out what the problem is with this last one.

The point parameter with the move action on it that moves the symbol does not also move the basepoint. Simply go into the block editor, click once on the move action associated with the paramter I had mentioned, right click, modify selection and make sure that the base point is selcted along with everything else.

The point parameter with the move action on it that moves the symbol does not also move the basepoint. Simply go into the block editor, click once on the move action associated with the paramter I had mentioned, right click, modify selection and make sure that the base point is selcted along with everything else.

Thanks Mike.