dsibbo Posted April 23, 2013 Posted April 23, 2013 Can anyone help me with this block. When I insert it into a drawing I can switch between 2 blocks on the drop down menu. The only problem is when I change between the 2 the position of the block moves. They don't appear to have the same base point, even though they are on top of each other within the block and positioned at 0,0,0. You can notice with the Emergency fitting that the E is way out when switched between the fittings. Even though within the block it is set up right next to it. Low Energy Downlighter_.dwg Quote
ReMark Posted April 23, 2013 Posted April 23, 2013 Have you tried editing the block to correct the problem? Quote
dsibbo Posted April 23, 2013 Author Posted April 23, 2013 Have you tried editing the block to correct the problem? Yes I cannot work out why it won't work. As far as I am aware I have done everything as it should be. Quote
SLW210 Posted April 23, 2013 Posted April 23, 2013 I know the block is different, but the problem seems to be the same. Quote
dsibbo Posted April 23, 2013 Author Posted April 23, 2013 Similar type of problem, although the answer from the last problem doesn't work with this problem. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.