Hey guys, I'm pretty new to all this autocad mesh stuff, So I got a question, is it possible to refine object without smoothing it ? I need more grids for measurement of specific places of Object (In my case measured church). So I need lots of grid lines to be able to snap with ruler and measure lengths and heights. All I found was to convert my 3d faces to single object, then convert it to mesh and refine few times to get a dense grid of the object then just explode it or leave it to be. But it requires the object to be smooth level one. So this is not the solution, cause I need object to be as it is now AKA not smoothed.