chelsea1307 Posted June 29, 2009 Share Posted June 29, 2009 Im working on a dwg created by someone else, when i draw on layer HW which has linetype HW the spacing is totally different then whats already there. Ive tried match properties but that doesnt change anything. Im to the point of have to copy lines already drawn and stretching and rotating to fit where i need. any idead why this is happening? Quote Link to comment Share on other sites More sharing options...
ReMark Posted June 30, 2009 Share Posted June 30, 2009 Could it be a metric/imperial problem or vice-versa? Quote Link to comment Share on other sites More sharing options...
Gary_W Posted July 2, 2009 Share Posted July 2, 2009 Check that your LTSCALE and PSLTSCALE are set the same as the chap who created the initial drawing? Gaz... Quote Link to comment Share on other sites More sharing options...
CADformat Posted April 23, 2010 Share Posted April 23, 2010 It could be metrical problem.I had that before using drawings created by someone else Quote Link to comment Share on other sites More sharing options...
nukecad Posted April 23, 2010 Share Posted April 23, 2010 Metric / Imperial sounds about right. But you say 'Layer HW' and 'Linetype HW' Have you tried drawing in Linetype HW on a different layer or a different linetype on layer HW? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.