inventor sketch to autocad sketch posible?

[matulja87]

im running inventor 2010 and i have a sketch of a sprocket (cut out of 3/4 plate). i then need the sketch in autocad 2008 so i can send it off to be torched on an nc cutting table. i realy dont want to redraw the sketch again. is there any tricky magical way to accoplish this???

[kencaz]

This link might help.

http://discussion.autodesk.com/forums/message.jspa?messageID=6224705

 

I have a similar issue in inventor 10. Sometimes I need export a 2D profile for our waterjet. I have to create an .idw file with the proper views of my feature, then export to dwg, open in Autocad, clean it up and save again as 2007 format.

 

Hopefully, 2010 will be in my near future.

 

KC

[matulja87]

thanks kencaz it worked just like you said i realy apreciate it.